Quick Installation Guide

13
A Setup complete screen will be displayed on the
app when completed.
Congratulations! Your camera is up and running!
The camera’s green power LED and orange Internet
LED should be on. As on the left, your camera
should be listed on the EdiLife home screen. Tap
your camera to see a live stream.
Use the app to view the stream anytime you are
connected to the Internet.
8. If you have a microSD card, insert the card into the microSD slot on the
back on the network camera.
II-3 WPS (Wi-Fi Protected Setup)
The WPS button is a quick and easy alternative to establish a secure wireless
connection between your network camera and your wireless router/access
point.
1. Press and hold the WPS button on your wireless router/access point for
the correct length of time to activate its
WPS.
Please check the instructions for your
wireless router/access point for how long
you need to hold down its WPS button to
activate WPS.
2. Within two minutes, press the WPS/Reset button on the network
camera for 2 – 5 seconds to activate WPS. The green LAN LED will flash
slowly to indicate that WPS is active.
Take care not to hold the WPS/Reset button too long and reset your
network camera.