User Manual

45
CONFIGURE SNMP TRAP INFORMATION

Basic Settings
。 Trap Mode
The system enables the SNMP “v1, v2c and v3” authentication by default. Users can enable the
SNMP server only on “v1 and v2c” or “v3”. “None” indicates disabling the SNMP server.
。 Inform Retry
The SNMP trap will send “Retry” times when the trap set to “v2 Inform” or “v3 Inform” mode.
The range of the Inform Retry is from 1 to 100.
The default Inform Retry is 5.
。 Inform Timeout
The interval is used to send trap when the trap set to “v2 Inform” or “v3 Inform” mode.
The range of the Inform Retry is from 1 to 300 second(s).
The default Inform Retry is 1 second.
。 Trap Receiver IP
The IP address is the IP address of the trap server to receive the trap information.
。 Community
The string in the SNMP trap is the identity of the device.
The max length for the Community is 32 characters.
Note: #, \, ', ", ? are invalid characters.

SNMPv3 Trap/Inform Settings
This section is displayed only when Trap Mode are set to “v3 Trap” or “v3 Inform”.