User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
98
III-9. Web Management – MAC Table
MAC address is Media Access Control address, which is used in layer 2 switching. AMAC Address table is
maintained by the switch to transmit frames more efficiently. When the switch receives a frame, the
system will check the MAC table and forward the frame to the corresponding port. The MAC Address
table is built dynamically by the received frames and when the system receives a frame with an
unknown MAC address, it floods the frame to all LAN ports in the same VLAN. When the destination
device replies the system identifies the MAC Address and the target port.
Configure Static MAC Address Information
•
VID
The VID is the VLAN group ID, which contains the configured MAC Address.
The range of the VID is from 1 to 4094.
•
MAC Address
This field is the static MAC Address of the configured member ports in the VLAN group.
•
Group Member
The Group Member is the port(s) in the VLAN group, to which the configured MAC Address belongs.
•
: Click the plus icon to add a static MAC Address row.
•
: Click the remove icon to delete the static MAC Address row.
•
(Apply Button)
After configuring above fields, click "Apply" button to make the changes effective.