User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
104
UPGRADE FIRMWARE PROCESS - UPLOADING FIRMWARE FILE
The following steps are performed when the system starts to upgrade after the "Apply" button is clicked:
1. Uploading the firmware image
The progress bar displays the uploading percentage.
2. Verifying the uploaded file
When the file is 100% uploaded, the system starts to verify the uploaded file to make sure it is valid.
By default, the firmware image is encrypted to prevent the attack on man-in-the-middle. Optionally,
higher encryption methodology is also provided.
3. Installing the uploaded firmware image
The new firmware will install after the system validates it.
4. Rebooting the system
The system will reboot automatically if the firmware is upgraded without any issue.
The progress bar displays the rebooting progress.