User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
111
3. An Ethernet Status window will pop up. Please click on the Properties button as shown in the
figure down below.
4. An Ethernet Properties window will pop up. Please double click on the Internet Protocol
Version 4 (TCP/IPv4).
5. An Internet Protocol Version 4 (TCP/IPv4) Properties window will pop up. Please set your PC’s
IP address and subnet mask as shown in the figure down below.
By default, your product’s IP address should be 192.168.2.1.You can set any IP address as long
as it’s not the same with your product’s IP address and is in the same network segment with
your product’s IP address.
Press OK to apply the TCP/IPv4 settings you just made. Now you can connect to your product
using a web browser (i.e. Internet Explorer, Chrome, or Firefox).