User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
114
SYSTEM GROUP
Command
Explanation
Mode
erase startup-config
Reset to factory default and reboot
Configure
exec-timeout [MINUTE] [SECOND]
Set idle timeout [MINUTE] [SECOND]
Configure
hostname [HOSTNAME]
Set Switch Host Name
Configure
reboot
Reboot the switch
Configure
system contact [CONTACT]
Set system contact
Configure
system location [LOCATION]
Set device location
Configure
username [USER_ID] [PASSWORD]
Configure username and password
Configure
show exec-timeout
Display idle timeout
Configure
show hostname
Display Switch Host Name
Configure
show environment power [1|2]
Display power 1/2 status
Configure
show event status relay
Display relay status
Configure
show system contact
Display system contact
Configure
show system description
Display system description
Configure
show system location
Display system location
Configure
show system mac
Display system MAC address
Configure
show system uptime
Display system uptime
Configure
show system version firmware
Display system version
Configure
show transceiver ddm
Display transceiver DDM information
Interface
show transceiver info
Display transceiver information
Interface
show transceiver raw
Display transceiver raw data
Interface
show username
Display admin ID
Configure
no exec-timeout
Default idle timeout
Configure
no hostname
Default Switch Host Name
Configure
no system contact
Clear system contact
Configure
no system location
Clear device location
Configure
no username
Default username and password
Configure
SERVICE CONTROL GROUP
Command
Explanation
Mode
service [http | https | ssh | telnet] enable
Enable service http, https, ssh, or telnet
Configure
show service [http | https | ssh | telnet] Display service http, https, ssh, or telnet state Configure
no service [http | https | ssh | telnet]
Disable service http, https, ssh, or telnet
Configure
IPV4 GROUP
Command
Explanation
Mode
ip address [IP_ADDR] [MASK]
Set IPv4 address and netmask
Configure
ip default-gateway [DEFAULT_GATEWAY_ADDR]
Set default gateway address
Configure
ip name-server [NAME_SERVER_IP]
Set Domain Name-Server
Configure
ip ping [IPV4_ADDR] [<size PKG_SIZ> | <repeat
PKG_CNT>]
Issue an IPv4 ping command Configure
show ip address
Display Host address of IPv4
Configure
show ip default-gateway
Display default gateway address
Configure
show ip mode
Display IP mode (Static or Dynamic)
Configure
show ip name-server
Display Domain Name-Server
Configure
no ip address
Delete IPv4 address
Configure
no ip default-gateway
Clear the default gateway address
Configure
no ip name-server
Clear the domain name-server
Configure