User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
9
I-4. DIN-Rail Mounting
The DIN-Rail clip is already attached on the rear side of the switch supports EN 50022 standard DIN Rail,
in the following diagram includes the dimension of EN 50022 DIN Rail.
Follow the steps below to mount the switch on the DIN-Rail track.
1. Insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its upper side
2. Lightly push the bottom of the DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is tightly attached to the track.
4. To remove the switch from the track, reverse the steps above.