User Manual

129
no event syslog [power1|power2]
Unregister an event of power 1 or 2 failure
Configure
no event syslog warm-start
Unregister an event of warm-start
Configure
MAC ADDRESS TABLE GROUP
Command
Explanation
Mode
clear mac address-table dynamic
Flush dynamic MAC addresses in MAC table
Configure
mac address add [VID: 1-4094] [MAC_ADDR] [PORT]
Set a MAC address to MAC table
Configure
show mac address
Display MAC table
Configure
no mac address [VID: 1-4094] [MAC_ADDR]
Remove a MAC address from FDB
Configure
USB GROUP
Command
Explanation
Mode
usb auto-backup
Auto save to USB if running config is changed
Configure
usb auto-load
Auto load config from USB to switch
Configure
show usb auto-backup
Display USB auto backup activated status
Configure
show usb auto-load
Display USB auto load activated status
Configure
no usb auto-backup
Disable auto save
Configure
no usb auto-load
Disable auto load
Configure
FILE GROUP
Command
Explanation
Mode
copy running-config startup-config
Save running-config to startup-config
Configure
copy running-config usb [file]
Save running-config to USB
Configure
copy startup-config running-config
Restore from startup-config
Configure
copy usb firmware [file]
Upgrade firmware from USB
Configure
copy startup-config usb [file]
Save startup-config to USB
Configure
copy usb startup-config [file]
Restore startup-config from USB
Configure
upload file name [FILE_NAME]
Set uploading file name
Configure
upload server ip [SERVER_IP]
Set uploading server IP
Configure
upload tftp
Upload and update firmware via TFTP (slower)
Configure
upload wget
Upload and update firmware via HTTP (faster)
Configure
show upload file name
Display uploading file name
Configure
show upload server ip
Display uploading server IP
Configure
no upload file name
Default uploading file name
Configure
no upload server ip
Clear uploading server IP
Configure