User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
42
CONFIGURE SNMP TRAP INFORMATION
•
Basic Settings
。 Trap Mode
The system enables the SNMP “v1, v2c and v3” authentication by default. Users can enable the
SNMP server only on “v1 and v2c” or “v3”. “None” indicates disabling the SNMP server.
。 Inform Retry
The SNMP trap will send “Retry” times when the trap set to “v2 Inform” or “v3 Inform” mode.
The range of the Inform Retry is from 1 to 100.
The default Inform Retry is 5.
。 Inform Timeout
The interval is used to send trap when the trap set to “v2 Inform” or “v3 Inform” mode.
The range of the Inform Retry is from 1 to 300 second(s).
The default Inform Retry is 1 second.
。 Trap Receiver IP
The IP address is the IP address of the trap server to receive the trap information.
。 Community
The string in the SNMP trap is the identity of the device.
The max length for the Community is 32 characters.
Note: #, \, ', ", ? are invalid characters.
•
SNMPv3 Trap/Inform Settings
This section is displayed only when Trap Mode are set to “v3 Trap” or “v3 Inform”.
。 Username