User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
46
CONFIGURE DHCP SERVER INFORMATION
•
Server Status
Shows the status of the DHCP server: Down or Up.
•
Server Mode
“Enable” or “Disable” the DHCP Server function.
•
Start IP Address
Set the range of the IP pool. The “Start IP Address” is the starting.
“Start IP Address” must be in the same subnet as that of the switch itself.
•
End IP Address
Set the range of IP pool. The “End IP Address” is the end.
“End IP Address” must be in the same subnet as that of the switch itself.
•
Default Gateway
Set the Default Gateway for the DHCP Clients to make them connect to the WAN.
“Default Gateway” must be in the same subnet as that of the switch itself.
•
DNS Server
Set the DNS Server for the DHCP Clients to make them connect to another device based on the URL
instead of IP address.
•
Lease Time
DHCP Server leases an IP address to a device for a period of time. When the lease time expires, the
DHCP server may assign a different IP address in the pool to the device.
•
(Apply Button)
After configuring above fields, click "Apply" button to make the changes effective.