User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
66
CONFIGURE IGMP SNOOPING QUERIER INFORMATION
•
Basic Settings
。 Mode
“Enable” or “Disable” the IGMP Snooping Querier function. If it is enabled, the system sends IGMP
snooping version 1 and 2 queries.
。 Querier Interval
This period is the interval to send the IGMP snooping queries.
The range of the Querier Interval is from 1 to 3600 seconds.
The default Querier Interval is 125 seconds.
。 Query Max Response Time
This is a timer to wait for the member response of the IGMP groups. It is used in removing the
information of the IGMP groups if no member responds to the query.
•
Query Version Settings
The Query Version Settings is configured for per-VLAN query.
。 VLAN ID
The field is to fill in the VLAN ID to configure the IGMP Snooping query version.
。 State
“Enable” or “Disable” the IGMP Snooping query on the configured VLAN ID.
。 Version
Set the IGMP Snooping version (v1, v2c, v3) on the specific VLAN.
•
(Apply Button)
After configuring above fields, click "Apply" button to make the changes effective.