User Manual
Table Of Contents
- Intended Readers
- Icons for Note, Caution, and Warning
- I. Product Overview
- I-1 . Product Brief Description
- I-2. Product Specification
- I-3. Hardware Description
- I-4. DIN-Rail Mounting
- /I-5. Console Connection
- The Console port is for local management by using a terminal emulator or a computer with terminal emulation software.
- DB9 connector connect to computer COM port
- Baud rate: 115200bps
- 8 data bits, 1 stop bit
- None Priority
- None flow control
- I-6. Connecting Cable
- II. Preparing for Management
- III. Web Management
- III-1. Web Management - Overview
- III-2. Web Management – Basic Settings
- III-3. Web Management – Redundancy
- III-4. Web Management – Management
- III-5. Web Management – L2 Switching
- III-6. Web Management – Security
- III-7. Web Management – Diagnostics
- III-8. Web Management – Monitoring
- III-9. Web Management – MAC Table
- III-10. Web Management – Maintenance
- Appendix A: IP Configuration for Your PC
- Appendix B: CLI Command Reference
- Revision History
- Federal Communication Commission Interference Statement
- R&TTE Compliance Statement
88
III-7-2. DIAGNOSTICS – PING
Ping is a tool used to test the reachability of a device on the IP network. Ping is enabled by sending
Internet Control Message Protocol (ICMP) request to the target device and waits for the response
packet from the target device to check the connection.
Ping Another Device with IPv4/IPv6
•
Type
Ping a connected device with “IPv4” or “IPv6” protocol.
•
IP Address
The IP address of the connected device is verified based on the type.
•
Count
Sets the count times. The system will send “Count” number ICMP packets to the specific IP address
and wait for the response.
The range of the Count is from 3 to 50.
The default Count is 3.
•
Result
The result of the ping shows the response from the specific IP address. If the specific IP address does
not respond, “No Response” will be displayed.
•
“Start” Button
Click the “Start” Button to start the ping to the IP address.
•
“Stop” Button
Click the “Stop” Button to stop the ping to the IP address before the count is completed.
•
“Clear” Button
Click the “Clear” Button to clear the “Result”.
•
“Reset” Button
Click the “Reset” Button to clear the “Result” and reset the “IP Address” and “Count” number.