User Manual

28
IV Browser Based Configuration Interface
Some functions of the browser based configuration interface are
disabled for different mode settings, please refer to the sections
applicable for your desired mode.
The browser-based configuration interface enables you to configure the
device’s advanced features. The OAP1300 features a range of advanced
functions such as MAC filtering, MAC RADIUS authentication, VLAN
configurations, up to 32 SSIDs and many more. To access the browser based
configuration interface:
1. Connect a computer to your access point using an Ethernet cable.
2. Enter your access point’s IP address in the URL bar of a web browser.
The access point’s default IP address is 192.168.2.2.
3. You will be prompted for a username and password. The default
username is “admin” and the default password is “1234”, though it was
recommended that you change the password during setup (see II-5
Basic Settings).
If you cannot remember your password, reset the access point back to its
factory default settings. Refer to I-5 Reset.