User Manual

62
Tx Power
Set the power output of the wireless radio. You may not
require 100% output power. Setting a lower power output can
enhance security since potentially malicious/unknown users in
distant areas will not be able to access your signal.
Beacon
Interval
Set the beacon interval of the wireless radio. The default value
is 100.
Station idle
timeout
Set the interval for keepalive messages from the access point
to a wireless client to verify if the station is still alive/active.
Beamforming
Beamforming is a signal processing technique used in sensor
arrays for directional signal transmission or reception.
This is achieved by combining elements in an antenna array in
such a way that signals at particular angles experience
constructive interference while others experience destructive
interference. Beamforming can be used at both the
transmitting and receiving ends in order to achieve spatial
selectivity. The improvement compared with omnidirectional
reception / transmission is known as the directivity of the
array.
Airtime
Fairness
Airtime Fairness gives equal amounts of air time (instead of
equal number of frames) to each client regardless of its
theoretical data rate.
Set airtime fairness to “Auto”, “Static” or “Disable”.
Auto: Share rate is automatically managed.
Static: Press “Edit SSID Rate” to manually enter a % for each
SSID’s share rate as shown below:
The % field must add up to 100% or a message will be
displayed:
Airtime fairness is disabled if “Disable” is selected.
Press “Apply” to apply the configuration, or “Cancel” to forfeit the changes.