Quick Installation Guide

III Quick Setup

This quick setup is a guide to setting up your Office 1-2-3 high speed Wi-Fi

network. Please note that these sections can be revisited later on for further

configurations, but will serve as the basics of the system.

III-1 Initial Setup– Computer

The initial setup is a simple step-by-step process to start up the web user

interface. Please follow the steps below:

1. Connect your computer to the PoE Switch using an Ethernet cable.

2. Connect the 3 access points to the PoE Switch using Ethernet cables.

Please make sure the Ethernet cable is connected to the PoE port of the

access point as shown below:

NOTE: One of the APs has a Master sticker while the other two have

Slave stickers, indicating their relationships.

If you need to, remove the cap from the underside of the access point.

This creates extra space for your cables to pass through.