User Manual

Office 1-2-3 Interface
147
Radio Group Settings
Wireless
Enable or disable the access point group’s 2.4GHz or 5GHz
wireless radio. When disabled, no SSIDs on that frequency will
be active.
Band
Select the wireless standard used for the access point group.
Combinations of 802.11b, 802.11g, 802.11n & 802.11ac can
be selected.
Auto Pilot
Enable/disable auto channel selection. Auto channel selection
will automatically set the wireless channel for the access point
group’s 2.4GHz or 5GHz frequency based on availability and
potential interference. When disabled, select a channel
manually.
Auto Pilot
Sensitivity
Select sensitivity of Auto Pilot.
Auto Pilot
Range
Select a range from which the auto channel setting (above)
will choose a channel.
Auto Pilot
Interval
Specify a frequency for how often the auto channel setting
will check/reassign the wireless channel. Check/uncheck the
“Change channel even if clients are connected” box according
to your preference.
Channel
When Auto Pilot is disabled, select a channel (1-11) manually.
Channel
Bandwidth
Set the channel bandwidth or use Auto (automatically select
based on interference level).
BSS
BasicRateSet
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
These settings are for experienced users only. Please do not change any of the
values on this page unless you are already familiar with these functions.
Changing these settings can adversely affect the performance of your
access points.
Advanced Settings
Contention
Slot
Select “Short” or “Long” – this value is used for contention
windows in WMM (see 錯誤! 找不到參照來源。 錯誤! 找不到參照來
源。).