Operation Manual

10
II-1. Access Point Mode: Zero Setup
Just plug in and connect the RE11S to your router with an Ethernet cable
as shown below. The RE11S will automatically link to your router and use the
Wi-Fi name and password on your access card.
You can also use iQ Setup to set up Access Point Mode instead, as shown in
II-2. iQ Setup. With iQ Setup you can set your own Wi-Fi name, password
and IP address.
1. Connect the network port of your RE11S to the LAN port of your existing
router using an Ethernet cable.
2. Plug the RE11S into a power socket.
3. The green power LED will flash while the extender is starting up. The
device is ready when the green power LED displays on.