Operation Manual

Beacon Interval

Set the beacon interval of the wireless radio.

The default value is 100.

DTIM Period

Set the DTIM period of wireless radio. The

default value is 3.

Data Rate

Set the wireless data transfer rate. The

default is set to Auto.

N Data Rate

Set the data rate of 802.11n. The default is

set to Auto.

Channel Width

Select wireless channel width (bandwidth

used by wireless signals from the device) –

the recommended value is Auto 20/40MHz.

Preamble Type

Set the wireless radio preamble type. The

default value is “Short Preamble”.

CTS Protect

Enabling this setting will reduce the chance

of radio signal collisions between 802.11b

and 802.11g wireless access points. It’s

recommended to set this option to “Auto”.

Tx Power

Set the power output of the wireless radio.

You may not require 100% output power.

Setting a lower power output can enhance

security since potentially malicious/unknown

users in distant areas will not be able to

access your signal.

Tx power works in conjunction with the switch on the side of

the device. The switch is the primary setting and the Tx

power value here will be a percentage of the slide switch

setting. E.G If the slide switch is set to Green Mode (25%) and

Tx power to 75%, the overall output will be 75% of 25%.