Quick Installation Guide

4
Step 3: Set the second RE11S into Extender Mode:
1. Power up the second RE11S by plugging it into a power socket near the master RE11S and wait for the
Power LED to turn on.
2. Press and hold the WPS button of the master RE11S for 3 seconds.
3. Within 2 minutes, press and hold the WPS button of the second RE11S. Both 5G and 2.4G LED should
be flashing initially.
4. The setup is complete if either a) only one of the LED flashes, or b) only one of the LED stays turned on.
NOTE: Please go back to
instruction 2 if both LED are
still flashing
Step 4: Relocate the second RE11S
1. Please relocate the second RE11S to achieve the desired coverage.
For maximum coverage, relocate the RE11S to where signal strength is at Good Performance.
2. Observe the Wi-Fi LED behavior to determine whether the location is appropriate.
3. Repeat instruction 2 if signal is poor.
NOTE:
Wi-Fi LED
Connection Quality
On
Excellent Performance
Slow Flash
Good Performance
Quick Flash
Poor Performance
Off
No Signal
Congratulations!
The Home Wi-Fi system setup is completed! Each user will only require one network name and password
for your Wi-Fi system.