Quick Installation Guide

6. Follow the on-screen instructions for your selected mode to complete

setup. You can configure the product for 2.4 GHz and/or 5GHz Wi-Fi.

To switch devices between “master” and “slaves”, unplug any Ethernet

cables and reset the devices back to factory defaults and then setup again.

IV. Reset the Extender

If you experience problems with your extender

or if you want to change the extender to a

different operating mode, you can reset the

device back to its factory settings. This resets

all settings back to default.

1. Press and hold the WPS button for at least

10 seconds and release when the green

power LED is flashing.

2. Wait for the extender to restart. The

extender is ready for setup when the green

power LED displays on.