Operation Manual

Remote IP Address

Enter the remote IP address range which will

activate the QoS rule.

Enter a starting IP address in the left field

and the end IP address in the right field to

define a range of IP addresses; or enter an IP

address in the left field only to define a single

IP address.

Remote Port Range

Enter the remote port range to activate the

QoS rule.

Enter a single port number e.g. 110 or a

range of port numbers e.g. 110-120

Traffic Type

Select traffic type as an alternative to

specifying a port range above.

Protocol

Select a “TCP” or “UDP” protocol type.

Save

Click ‘add’ button to add a new QoS rule

(detailed instructions will be given below).

QoS rule entries will be listed in the “Current QoS Table” as shown below.

Select a rule using the “Select” checkbox.

When using the “Edit” button only one rule can be selected each

time.

QoS rules will be processed in the order that they are listed i.e.

the rule at the top of the list will be applied first, and then the

second rule etc. The order can be adjusted using the “Move

Up/Down” buttons.

Edit

Edit a selected rule.

Delete Selected/

Delete All

Delete selected or all entries from the

table.

Move Up/Down

Move selected rule up or down the list.