User Manual

III-3-4. LAN

You can configure your Local Area Network (LAN) on

this page. You can enable the router to dynamically

allocate IP addresses to your LAN clients, and you can

modify the IP address of the device. The device’s default IP address is

192.168.2.1.

You can access the browser based configuration interface using

the device’s IP address instead of using the URL

http://edimax.setup.

IP Address

Specify the IP address here. This IP address will

be assigned to the RG21S/RA21S and will

replace the default IP address.

Subnet Mask

Specify a subnet mask. The default value is

255.255.255.0

802.1d Spanning

Tree

Select “Enable” or “Disable” to enable/disable

802.1d Spanning Tree. This creates a tree of

connected layer-2 bridges (typically Ethernet

switches) within a mesh network, and disables

those links that are not part of the tree, leaving

a single active path between any two network

nodes.

Your device’s DHCP server automatically assigns IP addresses to computers on its

network, between a defined range of numbers.