Quick Installation Guide

ManualsBrandsEdimax ManualsCamera & Photo3Mpx PoE True Day & Night WDR Vandal Dome Network Camera

3Mpx PoE True Day & Night WDR

Vandal Dome Network Camera

Thank you for purchasing this product.

Before you use the product, please check the package

contents. If any item is missing, contact your dealer of

purchase to claim the missing item(s).

Package Contents:

No.

Description

Quantity

Network IP camera

PU foam pad

CDROM with user manual, QIG and EdiView 32

QIG

Tools package

Terminal block (2 pins x 1 & 5 pins x 2)

Summary of content (8 pages)

PAGE 1
3Mpx PoE True Day & Night WDR Vandal Dome Network Camera Quick Installation Guide Thank you for purchasing this product. Before you use the product, please check the package contents. If any item is missing, contact your dealer of purchase to claim the missing item(s). Package Contents: No.
PAGE 2
Installation of the Network IP Camera Please follow the instructions below to setup your new IP camera. 1. Attach the front cover using the tool and screws included in the tools package. 2. Attach the PU foam pad onto the bottom of the rear cover. 3. 4. Create your GPIO and power cable with the terminal blocks. Please refer to the chart below for definitions of the terminal blocks.
PAGE 3
motherboard. Terminal block definition: GPIO J17: 5 pins J18: 5 pins Pin No. Function Function Pin 1 AGND GND Pin 2 Audio Out Alarm In 1 Pin 3 Ext MIC In Alarm In 2 Pin 4 RS485 D+ Alarm Out P Pin 5 Pin 5 RS485 DGND 2 Power Pin No.
PAGE 4
5. 6. 7. 8. 9. Connect all of the cables to their respective terminals. Insert a micro SD/SDHC card (optional): please refer to the chart in chapter 1-1.4 of the user manual for the location. If the camera is connected to a PoE switch then the device can be powered without using the power adapter. Power on the camera and refer to the following chapters for guidance on how to access and configure the camera.
PAGE 5
Search for the camera on your network You can use a web browser to access the network IP camera’s user interface (U.I.) and view images from the network IP camera. The system requirements to view the network IP camera are: ˙OS: Microsoft Windows XP/Vista/7 ˙Browser: IE7, 8, 9 (32Bit) ˙Cell phone: 3GPP player 1. Open the utility “EdivewFinder.exe” from the CD-ROM: 2.
PAGE 6
IP address: 192.168.2.3 User name: admin Password: 1234 You can access the camera directly if your PC resides in the same sub-network. Otherwise, use “IPFinder.exe” to search for the camera and assign an IP address before accessing it. 2. Open Internet Explorer and enter the IP address in the URL bar. The user login screen will prompt you for a username and password (admin, 1234): 3.
PAGE 7
install the ActiveX plugin. For IE 9, the notification will be displayed at the bottom of Internet Explorer as shown below: Click “Allow” to install ActiveX plugin. 4. If you see the following message: “Windows Firewall has blocked some features of this program” then please click “Allow access” in order for the IP camera to function properly. 5. You may also be asked that if you want to allow changes to be made to your computer, as shown below. Please click “Yes” to allow changes.
PAGE 8
6. After installing the ActiveX plugin, you should be able to see the video stream from the camera. Please refer to the user manual for more detailed instructions.