Quick Installation Guide

Step 1) Hardware Installation

3. Connect the video (VGA) cable of the projector to the video (VGA) port (labeled as ‘VGA’) located at

the back of the WPS.

4. Connect the audio cable of external speaker (powered) or audio amplifier to the audio port (labeled

as ‘AUDIO’) located at the back of the WPS. (Skip this step if this is not required.)

6. Connect the power adapter to the power port of the WPS and then plug in the power adapter to the

electrical power socket on the wall.

7. Power on the WPS by pressing ‘PWR’ button located at the back of the WPS. ‘Power’ LED will be lit

when it is switched on.

8. Switch on the projector, and the Welcome Screen of the WPS will be displayed. Please write down

the 4-digit Login Code and the IP Address of the WPS. You need this information to install the

software.

5. Connect the network cable to the network port (labeled as ‘LAN’) located at the back of the WPS.

(Skip this step if you use wireless network connection).

1. Use the mounting bracket and screws to mount the Wireless Project Server (WPS) on the wall.

(Skip this step if this is not required.)

2. Connect the supplied antenna to the antenna connector located at the back of the WPS (labeled as

‘ANT’). Fasten and adjust the antenna to make it perpendicular to the ground.