User Manual

71
System Setup
Playlist OFF, ON
Selects whether the Playlist function (p. 49) will be used.
If the Playlist function is on, projects will play back in the order listed in the
playlist.txt saved in the root folder of the SD memory card.
3 Speaker
Parameter Value Function
Speaker
Switch
OFF, ON
This switches the internal speakers on/off.
* Even if this is set to on, no sound is played from the internal speakers during recording
standby or recording. The speakers also remain silent while headphones are being used.
4 Display Setup
Parameter Value Function
Bright 1–5–10
This adjusts the display’s contrast. Higher values emphasize the white areas of
the display.
Display
Timer
OFF, 2 sec,
5 sec, 10 sec,
20 sec
Sets the amount of time until the display becomes dark when no operations have
been performed on the R-44.
If you are operating the R-44 on battery power, use this setting to conserve
battery life.
Button Light
Auto,
Dim, Bright
Sets the button brightness. When set to Auto, the button light darkens linked to
the set time of the Display Timer.
Illumination OFF, ON
All buttons are dimly lit. Button positions are easily verified even in dark
locations.
5 System Setup
Parameter Value Function
Auto Off
OFF, 10 min,
30 min,
240 min
Specifies the time after which the power will turn off if no operation has been
performed. (Units: minutes)
Battery
Type
Alkaline,
Ni-MH
Sets the type of batteries you are using.
Choose the Alkaline setting if you are using alkaline batteries or Ni-MH if you
are using rechargeable nickel metal-hydride batteries.
* If you choose a setting that does not match the type of batteries that are actually
installed, the remaining battery power indication will be incorrect.
Ext-Power
Adaptor,
9.0/9.5/
10.0/10.5/
11.0/11.5/
12.0V
Sets the final voltage when using an external power source. The “Battery Low!”
message is displayed when the voltage of the external power source drops
below the set voltage and if the voltage drops further, the power automatically
turns off.
Output Sel
4-indiv
Sets the sound output type (p. 18).
The sound from each channel from LINE OUT is output without modification.
monitor Sound is output according to the output assignments
Sync Mode
Master
Sets the sync signal mode (p. 75).
These settings are for the transmission side.
Slave These settings are for the receiving side.
Project File WAV, BWF
This specifies the desired format of the project files created during recording or
editing. If you select WAV, a conventional WAV file will be created. If you
select BWF, a BWF file containing information about the recording time and
recording device (Roland R-44) will be created.
Parameter Value Function