User`s manual

Optimuss OS User’s Manual
3. Configuring Satellite Connection
The start wizard takes you through the basic setup of your Optimuss OS.
Press the OK button on your remote control to get to the next step.
You will be asked if you want to set the basic settings for your Optimuss OS now or if you want to quit
the start wizard.
Using the Navigation buttons up and down select your desired option and press the OK button to
activate your selection.
If you choose “User wizard to setup basic features” you will be taken to the menu for the tuner
configuration.
A. Configuring Tuner A
Using LEFT/RIGHT key, you can choose one of the following Configuration Modes:
• Nothing configured
• Simple
• Equal to: mode to use the same configuration as that of Tuner B.
• Advanced: for an advanced user configuration.
If you choose Simple configuration mode. five modes are available for the satellite cable connection
between LNB and your Optimuss OS as below :
• Single
This option is used to receive a single satellite with a single LNB. The cable from LNB is directly
connected to Optimuss OS.
- 19 -