User`s manual

Optimuss OS User’s Manual
IV. Basic Operation
1. Turning your Optimuss OS on and off
Use the power button to turn your Optimuss OS on and off.
To put your Optimuss OS into standby mode either press the power button on your remote control or
directly on your Optimuss OS. The current time will be shown in the Optimuss OS’s VFD display.
Holding down the power button on your remote control for three seconds will put your Optimuss OS into
the deep standby mode.
You can also put your Optimuss OS into deep standby mode by using the OSD main menu. Choose the
option “Standby / Restart” in the OSD main menu and navigate to “Deep Standby” option afterwards.
Pressing the OK button will put your Optimuss OS into the deep standby mode.
This is the Standby / Restart menu. Navigate to the desired option and confirm by pressing the OK
button.
•Sleep timer: Put your Optimuss OS into standby after duration of time that
can be chosen freely. Please refer to the page 40.
•Standby: Puts your Optimuss OS into standby mode.
•Restart: Your Optimuss OS will be rebooted.
•Restart enigma: Your Optimuss OS will be restart enigma.
•Deep Standby: Puts your Optimuss OS into deep standby mode.
2. Service selection
Pressing the CH up/down buttons on your Optimuss OS remote control will take you to the previous or
next service.
Pressing the 0 will enable you to skip back and forth between the two most recently watched services.
This feature is quite useful during commercial breaks since it enables you to watch another channel and
quickly check if your movie is back on.
Using the “<” / “>” buttons left/right you can switch to the 20 last viewed services.
- 22 -