User Manual

ManualsBrandsEdsal ManualsFurnitureBW2472

Instructions : BW2472

Bulk Storage Rack

Should you have any comments, damage, missing parts, or problems with assembly

of this unit please feel free to contact our Muscle Rack manufacturing facility at,

(773) 475-3000 and request customer service. To obtain replacement parts, please

provide the following information :

- Model # - Part # & Description - Location Purchased - Date Purchased

General Instructions

2 - Welded End Frames

6 - Beams

3 - Particle Board Shelves

Parts

Safety Instructions

Muscle Rack Bulk Storage Rack is engineered to offer maximum flexibility as well as ease and quickness of assembly.

The rack units can stand individually, or for greater stability, be joined together using a common post. Individual beams

can be adjusted without disturbing the beams in adjoining units. These instructions should be followed exactly. All parts

supplied must be used as shown. Any alteration or deviation from this instruction sheet can result in unit failure. After

the unit is assembled, it must be placed on a level surface.

This rack unit must be placed on a level surface. Failure to do so can result in unit failure, poor product performance, or

a possible “tipping” safety hazard. Make sure all the beams are securely anchored to the post by using the plastic

push clips. Failure to do so can cause the beams to shift under load and “unhook” from the post slots. DO NOT

STAND ON THE UNIT OR USE THE UNIT AS A LADDER ! DO NOT OVERLOAD ! Evenly distribute the weight on

each shelf, and keep the heaviest loads on the bottom shelf. Use care when working with metal parts.

Assembly Instructions

Attach the beams to the welded end frames as seen in

figure 1. Use both welded end frames to establish the

left and the right sides of the units. After a beam has

been placed to the end units, place a plastic push clip

into the hole of the beam clip, then tap with a hammer

to drive the clip into the end frame post to secure the

beam to the end frame (see figure 1). Note: If the

beam end clip tabs become bent due to mishan-

dling. It may be necessary to adjust the tabs back

to their proper form.

The completed unit should have three (3) levels evenly

spaced for maximum stability. Note: Although the

beams are adjustable in height, it’s recommended to

evenly space them so that the stability of the unit is not

compromised.

After the beams are in place, the tie bars are now to be

fastened. Each level requires one (1) tie bar. Slide the

slot of the tie bar into the shelf ledge of the beam, and

align the hole located in the center of the beam to the

hole of the tie bar. Place the nut and bolt through the

holes and tighten appropriately (see figure 2).

Place the particle board shelving to each level to com-

plete the unit.

3 - Tie Bars

6 - Nuts and Bolts

12 - Plastic Push Clips

Made in the U.S.A.

Chicago, IL

Figure 1

Figure 2

Plastic

Push Clip

Beam

End Frame Post

Beam Shelf Ledge

Tie Bar

Particle Board Shelf

Tie Bar Slot

Beam End

Clip Tabs