Owner's manual

ManualsBrandsEdsal ManualsFurniturePromaxx CB721836

Assembly Instructions for Pro

Maxx Cabinets Page 4

Step 5 - Door Assembly

First the unit needs to be squared. Turn the unit upright

and place on a level floor. Loosen and re-tighten the

screws appropriately to ensure the unit is square. Now

the doors are ready to be hung. With the hinge pins

pointed down, select the door with three (3) holes for the

handle cutout (see figure 5 for assistance). This is the

right hand door. Take the right hand door and align the

door’s hinge pins with the companion hinges located on

the right side panel. Some of the hinge pins may have

moved or come out of alignment during shipping and

handling. If so, move the hinge pins back to the proper

position so that they align with the companion hinge

holes. Slowly slide the hinge pins into the holes to prop-

erly seat the door. Repeat the same process for the left

hand door.

Figure 5 - Door Assembly

Step 6 - Shelf Assembly

The unit is now ready for the shelves. Holding the shelf,

notice there are square and round cutouts on the edge of

the part. The square cutouts will install to the back of the

unit, and the round to the front. First select a level for

the shelf by selecting a set of square notches located

inside the unit on the back left and back right sides. A

series of round holes are located on the inside of the left

and right hand side panels near the hinges. Using a

shelf clip, insert the upper notch into a round hole oppo-

site the selected square holes where the shelf is to be

located. Push and “snap” the lower notch of the clip into

place using the next lowest round hole. Repeat the shelf

clip installation on the opposite corresponding side. To

insert the shelf, place the end with the square cutout to

the rear of the unit. Angle the shelf so that the shelf will

engage the square notches on the back and lower onto

the front shelf clips. Repeat the process for all remaining

shelves.

Figure 6 - Shelf Assembly

Step 7 - Final Assembly

To complete the unit, the locking handle needs to be in-

stalled on the right hand door. Follow carefully the as-

sembly instructions as written on the handle hardware

bag. Helpful hints on installation: The door rods will

slide into small plastic guides on the door. Install the

handle to the right hand door, then place the cam in posi-

tion. Slide the tip of the door rod into the lower plastic

guide and position the door rod onto the pin located on

the cam and hold it in place. Install the other door rod in

the upper plastic guide and position onto pin located on

the cam. Install the remaining hardware.

Figure 7 - Final Assembly