Certifications 2

EDSYN GMBH EUROPA
Zentrum für Löt- und Entlötsysteme
EDSYN GMBH EUROPA, Postfach 1169, D-97888 Kreuzwertheim
11.07.2019
EDSYN GMBH EUROPA • D-97892 Kreuzwertheim • Finkenweg 2 •  (09342) 6413 

 (09342) 6417
4.) FIRST AID MEASURES
General information:
After inhalation:
After skin contact:
After eye contact:
After swallowing:
Ingestion:
Take affected persons out into the fresh air.
Take affected persons out of danger area and lay down.
Take affected persons into fresh air. If irritation persists, get medical
attention. Always carry out soldering and melting operations in well
ventilated areas to prevent a concentration of fumes higher to the MAC
values.
Immediately wash with water and soap and rinse thoroughly. If skin
irritation persists, get medical attention. If burns should occur from molten
metal, treat for burn and get medical assistance if necessary. Burns: cool
affected parts under running water. Do not remove adhering material,
apply a sterile dressing and seek medical advice. May cause sensitisation
by skin contact.
Rinse opened eye for several minutes under running water. Get medical
attention if irritation occurs. Immediately flood the eye with plenty of water
for at least 15 minutes. Obtain medical attention.
Call for a doctor immediately.
Do not induce vomiting unless directed to do so by medical personnel.
Do not give water when unconscious. Keep warm and at rest.
5.) FIRE FIGHTING MEASURES
Suitable extinguishing agents:
Extinguishing agents to avoid:
Special hazards caused by the
substance, its products of combustion
or resulting gases:
Protective equipment:
Non-flammable product
Dry chemical powder, water spray or foam (CO
2
), Alcohol resistant foam
Do not use water jet on fire where molten metal is present.
Molten metal produces fumes or vapours that may be sensitizing to
asthmatic persons.
Molten metal reacts violently with oxidising agents.
Wear appropriate self-contained breathing apparatus. Do not inhale
combustion gases. Wear full body protective clothing.
6.) ACCIDENTAL RELEASE MEASURES
Person related safety precautions:
Measures for environmental
protection:
Measures for cleaning/collecting:
Additional information:
Remove persons from danger area. Wear protective equipment. Keep
unprotected persons away. Use respiratory protective device against the
effects of fumes/dust. Ensure adequate ventilation. Wear appropriate
protective clothing.
Do not allow to enter sewers/surface or ground water.
After cooling, collect the released product and store it in sealed containers.
Wash the contamined surface with an organic solvant or a detergent.
Transfer into suitable containers for recovery or disposal.
Exposure levels indicated in section 8 are relevant to these and other
operations.