Installation Manual Original Instructions - Shop Press
Installation Manual 1 General Operator and Supervisor Information Signal Word Definition Signal Word Panel 2 Installating the Shop Press Environmental Requirements at Work Station Electrical Requirements at Work Station Receiving the Shop Press Unpacking/Moving the Shop Press Installing the 20 Ton Shop Press Installing the 40 Ton Shop Press 3 Hydraulic Power Powering with an Edwards Ironworker Powering with an Edwards Porta Power Table of Contents Signal Word Definition Operatorand SupervisorInforma
Shop Press Installation This manual provides installation requirements for the Edwards 20 Ton Shop Press and 40 Ton Shop Press. All Edwards hydraulic accessory tools are powered by an Edwards Ironworker or an Edwards Porta Power, portable hydraulic power-plant. Refer to Safety, Installation, Operations and Maintenance manuals for the Edwards power-plant you are using to operate your Edwards hydraulic accessory tool.
Hydraulic Power When disconnecting your Press, simply reverse procedure. Replace the safety cap at the push button port to restore power to your Ironworker. Powering with an Edwards Porta-Power Your Edwards Porta-Power 5hp / 3000psi / Portable Power Unit will power all your Edwards Hydraulic Accessories.
S P.O. Box 166, Albert Lea, MN 56007 800-373-8206 www.edwardsironworkers.
Maintenance Manual Original Instructions - Shop Press
Maintenance Manual 1 General Operator and Supervisor Information Signal Word Definition Signal Word Panel Maintenance Precautions 2 Maintenance Schedule Daily/Shift Change Visual Observation General Maintenance - Daily Table of Contents OperatorandSupervisorInformation This is one of four manuals supplied with your machine.
Maintenance Schedule General Maintenance - Daily Your Edwards Shop Press will benefit from reasonable care and periodic maintenance. Reasonable care includes daily visual observation, as well as general maintenance procedures at daily intervals by operator/maintenance personnel. Perform inspections and maintenance of the electrical, hydraulic, and mechanical systems of the Edwards hydraulic accessory connected to the Ironworker or Porta-Power as follows: Disconnect unit from power source.