User guide

ManualsBrandsEdwards Signaling ManualsSafety101 Series

P-047550-1297 ISSUE 6

Figure 5. Stacking the Modules on AdaptaLight

Base Unit

Table 2. Specifications

Figure 4. Wiring to the Terminal Block

Lamp Light Replacement Replacement

Catalog Number Voltage Current Sound Output Life Output Horn Lamp**

101BS-N5 120V 50/60 Hz 0.05A 85 dB at 10 ft. (3.05 m) -- __ 123A-N5 --

101BS-E1 12V DC 122-E1

101BS-G1 24V DC 122-G1

101SINH*-N5 120V 50/60 Hz 0.11A -- 25,000 hr.

†

70 lumens

-- 50LMP-12WH-D***

101SIN*-E1 12V DC 1.0A 1,520 hr.

†

189 lumens

Ind. Trade 94

101SINH*-G1 24V DC 0.32A 15,000 hr.

†

52 lumens

50LMP-9WH-D***

101SLED*-N5 120V 50/60 Hz 0.022A -- 100,000 hr.

†

-- -- --

101SLED*-G1 24V DC 0.062A

101FINH*-N5 120V 50/60 Hz 0.11A -- 25,000 hr.

†

70 lumens

-- 50LMP-12WH-D***

101FIN*-E1 12V DC 0.10A 1,520 hr.

†

189 lumens

Ind. Trade 94

101FINH*-G1 24V DC 0.32A 15,000 hr.

†

52 lumens

50LMP-9WH-D***

101FLED*-N5 120V 50/60 Hz 0.022A -- 100,000 hr.

†

101FLED*-G1 24V DC 0.062A

101ST*-N5 120V 50/60 Hz 0.12A -- 3,000 hr.

‡

300,000 -- 91B-ST

101ST*-E1 12V DC 0.5A peak candela

101ST*-G1 24V DC 0.3A

*Letter in this position specifies lens and LED color: A - amber, B - blue, C - clear, G - green, M - magenta, R - red.

NOTE:

LED modules are only available in amber, blue, green and red.

**The LED modules are permanently installed.

***A non-halogen bulb may be used in place of the halogen bulb as follows. For 120V models, use Lamp Industry Trade No. 15T7DC and for 24V DC models, use

Lamp Industry Trade No. 1692.

†

Projected lamp life based on manufacturer's calculated lamp life @ 65 fpm and 50% duty cycle.

‡

Calculated strobe tube life at operating power to 75% efficiency.

Manufacturer's lumen rating.

f. On DC models, connect the wires from the horn to the

terminal block. On AC models, connect wires using wire

nuts (not supplied).

Cleaning

The AdaptaLight module lens surfaces should be periodically

dusted and cleaned with a dry soft clean cloth to maintain opti-

mum light visibility. If necessary, the outer lenses may be cleaned

with water and a mild detergent on a well rung out soft clean

cloth.