Owner manual

P/N 3100378 ISSUE 1 © 2001
Installation Instructions for Screw Base Beacons
Description
The Edwards 110 Series are CE Marked Screw Base
Beacons that can be installed in a conventional light
socket. They are available in either strobe or flashing
incandescent and in five different lens colors. See Table
1 for additional specifications.
No disassembly or wiring required for installation.
Specifications
110ST*-N5 Strobe 120V AC 50/60 Hz
110FIN*-N5 Flashing Incandescent 120V AC 50/60 Hz
*Signifies lens color: A - amber, B - blue, C - clear, G -
green, or R - red
Installation
Screw beacon into a conventional light socket and apply
power.
Maintenance
Lamp Replacement for Incandescent Units
1. Disconnect power.
CHESHIRE, CT 203-699-3300 FAX [phone] (CUST. SERV.) 203-699-3078 (TECH SERV.)
2. Remove two screws from lens and remove lens as
shown in Figure 1.
3. Press down on bulb and turn counterclockwise to
remove.
4. Insert replacement bulb (Table 1) into lamp socket
(Figure 1), push down and turn clockwise until it
locks into place.
5. Ensure o-ring seal is in place and replace lens and
secure using two screws removed in step 2.
Strobe Tube Replacement for Strobe Units
1. Disconnect power.
2. Remove two screws from lens and remove lens as
shown in Figure 2.
3. Remove two screws securing the PC board to the
base and remove the PC board.
4. Disconnect the power wires from the terminal block
on the back of the PC board.
5. Connect the power wires to the terminal block on
the back of the new PC board. Insert the PC board
into the base and secure using the two screws
removed in step 3.
6. Ensure o-ring seal is in place and replace the lens
and secure using two screws removed in step 2.
Lens
Lamp
Lamp
Socket
O-ring
Lamp Base
Figure 1. Beacon Assembly
Catalog Number Description
110-LR Replacement Lens, Red
110-LA Replacement Lens, Amber
110-LB Replacement Lens, Blue
110-LG Replacement Lens, Green
110-LC Replacement Lens, Clear
110LS-ST-N5 Replacement Strobe Tube PC Board
Industry Std. 15T7DC Replacement Incandescent Lamp
Figure 2. Strobe Assembly
Lens
Strobe
Tube
(2) Screws Securing
PC Board to Base
O-ring
Lamp Base