Installation Guide

19
Active Time
The active time screen will display how long the unit has been actively
heating water. The time is displayed in HOURS:MINUTES
Total Time
This screen tells the user the total amount of time the unit has been on in
it’s lifespan
Setup
If the knob is pressed once on this screen, the user will be taken to all the
booster heating set up interface. ALL OF THE FOLLOWING SET UP CYCLE
SCREENS WILL ORIGINATE FROM PRESSING THE KNOB ONCE ON THIS
DISPLAY.
TankBuddy™ Built-In Freeze Protect Feature (Select Models Only)
While the TankBuddy™ is in Vacation Mode, if the temperature read at the inlet of the TankBuddy™ unit drops
below 60°F, the tank will automatically power on to prevent the nearby pipes from freezing and potentially
bursting. Once the temperature at the inlet of the TankBuddy™ exceeds 60°F again, the tank will power back off.
TankBuddy™ Set Up Menu Cycle Screens
Turn the control knob in either direction to cycle through menu options.
Activation Temperature
The first heater setting is the activation temperature. If the unit reads an
inlet temperature that below the activation temperature, the unit will turn
on. For instance, if the activation temperature is 115°, and water coming
into the unit is below 115°, the unit will turn on. To change this setting,
press the knob once, and a “*” will appear on screen. Turn the knob to
adjust temp, and then press the knob again to save the setting.
Max Temperature
Here you can set the maximum temperature you want the TankBuddy™ to
heat the water up to. To change the set temperature, press the knob once,
and a “*” will appear on screen. Turn the knob to adjust temperature, and
then press the knob again to lock in the setting.
ACTIVE
1:12
TOTAL
12345:12
SETUP
ENTER
ACTIVATE
115 F
ACTIVATE
* 115 F
MAX TEMP
120 F
MAX TEMP
* 120 F