Instructions / Assembly

ManualsBrandsEemax ManualsPlumbing ProductPoint of Use 9.5 kW 240-Volt 0.75gpm-2.0gpmThermostatic Electric Tankless Water Heater

“Thermostatic”

ELECTRIC INSTANTANEOUS WATER HEATER

INSTALLATION GUIDE AND OWNERS MANUAL

WARNING

BEFORE ATTEMPTING INSTALLATION OF THIS UNIT OR MAKING ANY

ADJUSTMENTS TO THE UNIT, ALWAYS BE SURE CIRCUIT BREAKER IS OFF

TO PREVENT DANGER OF SERIOUS ELECTRIC SHOCK.

FAILURE TO GROUND THE SYSTEM MAY RESULT IN SERIOUS INJURY OR DEATH

INSTALLER/ CONSUMER RESPONSIBILITIES

READ THIS MANUAL CAREFULLY BEFORE ATTEMPTING TO INSTALL OR

OPERATE THIS WATER HEATER. IF THE SAFETY RULES ARE NOT FOLLOWED,

THE UNIT WILL NOT OPERATE PROPERLY AND IT COULD CAUSE DEATH,

SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE.

WARRANTY OF THIS WATERHEATER WILL DEPEND

ON PROPER INSTALLATION AND OPERATION. THE WARRANTY

WILL BE VOID IF THE DESIGN HAS BEEN ALTERED IN ANY WAY

WHATSOEVER. THE MANUFACTURER OF THIS HEATER WILL NOT BE LIABLE

FOR ANY DAMAGES BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION

AND OPERATING INSTRUCTIONS OUTLINED ON THE FOLLOWING PAGES.

Eemax Inc., 353 Christian St. Oxford, CT. 06478

THE INSTALLATION MUST CONFORM WITH THE INSTRUCTIONS IN THIS

MANUAL AND LOCAL CODES, OR INTHE ABSENCE OF

LOCAL CODES, WITH THE LATEST EDITION OF THE

NATIONAL ELECTRICAL CODE. THIS PUBLICATION IS AVAILABLE FROM

YOUR LOCAL GOVERNMENT, ELECTRIC CO., PUBLIC LIBRARY, OR BY

WRITING UNDERWRITERS LABORATORIES, 333 PFINGSTEN RD.,

NORTHBROOK, IL. 60062

TEL:1-800-543-6163, 203-267-7890, FAX: 203-267-7975, e-mail: eemaxinc@aol.com

IF YOU REQUIRE HELP OR HAVE ANY QUESTIONS RELATING TO THE

INSTALLATION OR PERFORMANCE OF THIS HEATER, PLEASE CALL

OUR TECHNICAL SERVICE DEPARTMENT TOLL FREE:1-800-543-6163.

HAVE THE INFORMATION LISTED BELOW BEFORE CALLING:

MODEL NO.___________SERIAL NO.___________INSTALLATION DATE_____

COMPRESSION

NUT

PART# EX17

TRIAC

PART # EX 18

CONTROL BOARD

EX100/240 for 240v, 208v

EX100/277 for 277V

ELEMENT CARTRIDGE

HEATER MODEL/ORDER REF. CARTRIDGE REF #

EX2412T EX610

EX3012T EX480

EX3512T EX410

EX 55T EX 1050

EX 65T EX 890

EX 75T EX 770

EX 95T EX 630

EX 8208T EX 520

EX 60T EX 1280

EX 80T EX 960

EX 90T EX 850

EX 100T EX 760

Replacement Parts for “Thermostatic” Units

INSTANT COMFORT…ENDLESS SAVINGS

COMPRESSION

SLEEVE

PART # EX16

TEMP

ADJ

KNOB

RELAY

GROUND

WIRE

Summary of content (4 pages)

PAGE 1
Replacement Parts for “Thermostatic” Units ® INSTANT COMFORT…ENDLESS SAVINGS TRIAC PART # EX 18 “Thermostatic” ELECTRIC INSTANTANEOUS WATER HEATER INSTALLATION GUIDE AND OWNERS MANUAL RELAY ELEMENT CARTRIDGE HEATER MODEL/ORDER REF.
PAGE 2
GENERAL The Eemax “Thermostatic” heater is specifically designed to take in cold or preheated water and heat it to temperatures suitable for the normal domestic usage up to a maximum of 1400 F. To obtain optimum performance and energy savings, the unit should be located as close as possible to the point of use. The unit is supplied with compression rings and nuts suitable for direct coupling to 1/2” copper or plastic piping. Do not use additional screwed fittings or pipe dope.
PAGE 3
2) PLUMBING HOOK-UP 4) COMMISSIONING YOUR HEATER 1) The unit is supplied with compression fittings. USE THESE: DO NOT USE THREADED PIPE FITTINGS. DO NOT USE PIPE DOPE OR TEFLON TAPE ON THIS INSTALLATION. Ensure the inlet filter supplied with this unit is in place. IMPORTANT Before switching “on” the power at the breaker make sure that the hot water circuit is free of air pockets or premature failure of the heating element will occur.
PAGE 4
3) ELECTRICAL HOOK-UP FIGURE 2 4 1/4 inches WARNING BEFORE BEGINNING ANY WORK ON THE INSTALLATION BE SURE THAT THE BREAKER IS “OFF” TO AVOID ANY DANGER OF SHOCK. MOUNTING HOLES Your Eemax heater must have its own independent circuit using insulated, UL listed, 3 wire cable of the appropriate size suitable for use up to 75 oC protected by the correctly rated circuit breaker.