Install Instructions

ManualsBrandsEemax ManualsCooling & Air QualityFlow Controlled Electric Tankless Water Heater With Pipe Compression Fittings On Top Of Unit

“Flow Controlled”

ELECTRIC INSTANTANEOUS WATER HEATER

INSTALLATION GUIDE AND OWNERS MANUAL

WARNING

BEFORE ATTEMPTING INSTALLATION OF THIS UNIT OR MAKING ANY

ADJUSTMENTS TO THE UNIT, ALWAYS BE SURE CIRCUIT BREAKER IS OFF

TO PREVENT DANGER OF SERIOUS ELECTRIC SHOCK.

FAILURE TO GROUND THE SYSTEM MAY RESULT IN SERIOUS INJURY OR DEATH

INSTALLER/ CONSUMER RESPONSIBILITIES

READ THIS MANUAL CAREFULLY BEFORE ATTEMPTING TO INSTALL OR

OPERATE THIS WATER HEATER. IF THE SAFETY RULES ARE NOT FOLLOWED,

THE UNIT WILL NOT OPERATE PROPERLY AND IT COULD CAUSE DEATH,

SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE.

WARRANTY OF THIS WATERHEATER WILL DEPEND

ON PROPER INSTALLATION AND OPERATION. THE WARRANTY

WILL BE VOID IF THE DESIGN HAS BEEN ALTERED IN ANY WAY

WHATSOEVER. THE MANUFACTURER OF THIS HEATER WILL NOT BE LIABLE

FOR ANY DAMAGES BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION

AND OPERATING INSTRUCTIONS OUTLINED ON THE FOLLOWING PAGES.

Eemax Inc., 353 Christian Street Oxford, CT 06478

THE INSTALLATION MUST CONFORM WITH THE INSTRUCTIONS IN THIS

MANUAL AND LOCAL CODES, OR INTHE ABSENCE OF

LOCAL CODES, WITH THE LATEST EDITION OF THE

NATIONAL ELECTRICAL CODE. THIS PUBLICATION IS AVAILABLE FROM

YOUR LOCAL GOVERNMENT, ELECTRIC CO., PUBLIC LIBRARY, OR BY

WRITING UNDERWRITERS LABORATORIES, 333 PFINGSTEN RD.,

NORTHBROOK, IL. 60062

TEL:1-800-543-6163, 203-267-7890, FAX: 203-267-7975, e-mail: eemaxinc@aol.com

IF YOU REQUIRE HELP OR HAVE ANY QUESTIONS RELATING TO THE

INSTALLATION OR PERFORMANCE OF THIS HEATER, PLEASE CALL

OUR TECHNICAL SERVICE DEPARTMENT TOLL FREE:1-800-543-6163.

HAVE THE INFORMATION LISTED BELOW BEFORE CALLING:

MODEL NO.___________SERIAL NO.___________INSTALLATION DATE_____

COMPRESSION

NUT

PART# EX17

RELAY

PART # EX250-255

CONTROL BOARD

EX182DP for 240v, 208v

EX182SP for 120,277v

ELEMENT CARTRIDGE

HEATER MODEL/ORDER REF. CARTRIDGE REF #

EX 35 EX 1650

EX 55 EX 1050

EX 65 EX 890

EX 75 EX 770

EX 95 EX 630

EX 8208 EX 520

EX 60 EX 1280

EX 80 EX 960

EX 90 EX 850

EX 100 EX 760

Replacement Parts for “Flow Controlled” Units

COMPRESSION

SLEEVE

PART # EX16

INSTANT COMFORT…ENDLESS SAVINGS

RELAY

Summary of content (4 pages)

PAGE 1
Replacement Parts for “Flow Controlled” Units RELAY ® INSTANT COMFORT…ENDLESS SAVINGS RELAY PART # EX250-255 “Flow Controlled” ELECTRIC INSTANTANEOUS WATER HEATER INSTALLATION GUIDE AND OWNERS MANUAL ELEMENT CARTRIDGE HEATER MODEL/ORDER REF.
PAGE 2
GENERAL The Eemax “Closed Outlet Flow Controlled” heater is specifically designed to take in cold water only and heat it to temperatures suitable for the normal domestic usage up to a maximum of 1400 F. To obtain optimum performance and energy savings, the unit should be located as close as possible to the point of use. The unit is supplied with compression rings and nuts suitable for direct coupling to 1/2” copper or plastic piping. Do not use additional screwed fittings or pipe dope.
PAGE 3
2) PLUMBING HOOK-UP 4) COMMISSIONING YOUR HEATER IMPORTANT Before switching “on” the power at the breaker make sure that the hot water circuit is free of air pockets or premature failure of the heating element will occur. To do this open all hot water faucets one at a time for a minute or two until the water flow is continuous and free from “gulping” and from visible air pockets. 1) With inlet and outlet BALL VALVES fully open, turn on all hot water outlets.
PAGE 4
3) ELECTRICAL HOOK-UP FIGURE 2 4 1/4 inches WARNING BEFORE BEGINNING ANY WORK ON THE INSTALLATION BE SURE THAT THE BREAKER IS “OFF” TO AVOID ANY DANGER OF SHOCK. RELAY Your Eemax heater must have its own independent circuit using insulated, UL listed, 3 wire cable of the appropriate size suitable for use up to 75 oC protected by the correctly rated circuit breaker.