PAGE TWO EX-MODELS indicator Baht LL Rating labs! + # Wie #5 Order Rel a ait in Water ninetieth (Bottom | This Is how your Ea max "EX models should look whet mounted correctly on the wall: Any other mounting configuration ls wrong and he unl will nat work! Check fo see I vou have an "BEX model on tha UL rating label bn the front cover of your Bee max tpt, if the units are mounted correctly Bnd 81 do not products hot water then have look {0 see if the indicator light comes an when the hob water falconer is T
PAGE THREE The indicator light does not come on {when the hot Walter faucet is append: STET ONE. is the circuit breaker switched on al the breaker panel? YES: peep GU M0 Step WO NO siege underwater te faucet for a couple of minutes betel tiring ofr the breaker. Turn on breaker STEP TWO This unl will not suites on mes enough water Is Th wing through ihe heater You will need a fow rate of al 164s 0 55 gallons per mints voter 12 GB. Some models moire a Blower ow rate.
PAGE FOUR STEP THREE: YOu Will require a multi meter 7 voltmeter Io carry oul the next sells. DANGER! TURN OFF THE BREAKER BEFORE PROCEEDING WITH THE NEXT TESTS Get the meter to the single Ohms selling Da hal measure continuity this will not work.
PAGE FIVE The Indicator light comes on" bothered is no heal or he Walter temperature is low: STEP ONE. The water flow is foo nigh. Reduce the water flow using the faucet with experimentation you should notice an increase in imperative. STEP TWO! Make sire that the Units connected to the Voltage supp specified on the ULL. rating label on the front cover of the heater and no other. STEP THREE. Take resistance reading of he element. To do this follow instructions orf page four.
PAGE SIX Other possible solutions STEP ONE.