Use and Care Manual

Connection Reference 2

Connecting the pigtail cord from AutoBooster

to the tank heater:

1. The pigtail cord should be partially attached to the unit through the ground connection. With the

cover off, you should see an exposed red wire and black wire coming from the pigtail, on the end

that’s inside the unit. Connect the red wire to the “T1” labeled wire terminal, and the black wire to

the “T2” labeled terminal.

2. Tighten the connections on the terminal block with a flathead screwdriver. MAKE SURE WIRES ARE

INSERTED ALL THE WAY IN THE TERMINAL, AND THAT THE SCREWS SECURING THE CONNECTION

ARE TIGHT AND SECURE. FAILURE TO DO THIS WILL CAUSE HEATER MALFUNCTION. Wire

insulation should not be inserted into the terminal block as this will inhibit a good electrical

connection.

3. Take the green/yellow wire from the end of the pigtail, outside of the AutoBooster

, and connect

it to the existing ground connection on the tank heater’s terminal. If additional help is required,

reference your tank heaters manual and/or contact our customer service and technical support

team.

4. Replace the unit cover, control knob, and screws.

L1 L2 T1 T2