Use and Care Manual

1 - BEFORE INSTALLATION

PLEASE READ THESE INSTRUCTIONS THOROUGHLY AND COMPLETELY PRIOR TO INSTALLATION & USE.

FAILURE TO FOLLOW INSTRUCTIONS COULD CAUSE PROPERTY DAMAGE, SERIOUS PERSONAL INJURY, OR

DEATH.

By installing this product, you acknowledge the terms of the manufacturer’s warranty. Once the heater is

installed, do not return product to the place of purchase. If you have any questions regarding the warranty

or product return policies, please contact Eemax at 1-800-543-6163.

Inspect all components. The contents of your box should include the following components:

 AutoBooster™ Unit

 Cable Clamp (2x)

 Wire Nuts (2x)

 Pigtail Cord (1x)

What you will need to install:

 Phillips Head Screwdriver

 Flat Head Screwdriver

 Pipe Cutter

 Adjustable Wrench

 Teflon Tape

 Tape Measure/Ruler

 Pencil (recommended for marking measurements when cutting pipe)

 Needle-Nose Pliers (not required but may be beneficial)

2 - SELECTING A LOCATION TO INSTALL

This product is designed to be installed indoors only, in series with a tank water heater outlet.

DO NOT install this product in a location where it may be subject to freezing temperatures. If the water

inside your unit freezes, it can cause severe and permanent damage that is not covered under your

warranty.

DO NOT locate the water heater in a location that is difficult to access.

SCALD RISK: Make sure that the water heater and hot water outlet pipe are out of the reach of children so

they cannot tamper with the temperature controls or injure themselves by touching the hot water outlet

pipe. The outlet water pipe can get hot enough to scald.

This product does NOT require venting.