Instructions / Assembly

ManualsBrandsEemax ManualsPlumbing ProductSingle Point 4.1 kW 208-Volt 0.3gpm-2.0gpm Electric Tankless Water Heater

“Single Point”

ELECTRIC INSTANTANEOUS WATER HEATER

INSTALLATION GUIDE AND OWNERS MANUAL

WARNING

BEFORE ATTEMPTING INSTALLATION OF THIS UNIT OR MAKING ANY

ADJUSTMENTS TO THE UNIT, ALWAYS BE SURE CIRCUIT BREAKER IS OFF

TO PREVENT DANGER OF SERIOUS ELECTRIC SHOCK.

FAILURE TO GROUND THE SYSTEM MAY RESULT IN SERIOUS INJURY OR DEATH

INSTALLER/ CONSUMER RESPONSIBILITIES

READ THIS MANUAL CAREFULLY BEFORE ATTEMPTING TO INSTALL OR

OPERATE THIS WATER HEATER. IF THE SAFETY RULES ARE NOT FOLLOWED,

½’’ PIPE

(5/8’’OD)COMPRES

SION NUT AND

SLEEVE

PART# EX16, EX17

CONTROL BOARD

EX182DP

SPECIFY VOLTAGE

AND MODEL

Replacement Parts for “Single Point” Units

3/8’’ COMPRESSION

ADAPTOR WITH NUT

AND SLEEVE

PART#EX68A,B,C

INSTANT COMFORT…ENDLESS SAVINGS

INSTALL

THIS WAY UP

ONLY !

OPERATE THIS WATER HEATER. IF THE SAFETY RULES ARE NOT FOLLOWED,

THE UNIT WILL NOT OPERATE PROPERLY AND IT COULD CAUSE DEATH,

SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE.

WARRANTY OF THIS WATERHEATER WILL DEPEND

ON PROPER INSTALLATION AND OPERATION. THE WARRANTY

WILL BE VOID IF THE DESIGN HAS BEEN ALTERED IN ANY WAY

WHATSOEVER. THE MANUFACTURER OF THIS HEATER WILL NOT BE LIABLE

FOR ANY DAMAGES BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION

AND OPERATING INSTRUCTIONS OUTLINED ON THE FOLLOWING PAGES.

Eemax Inc., 353 Christian Street Oxford, CT 06478

THE INSTALLATION MUST CONFORM WITH THE INSTRUCTIONS IN THIS

MANUAL AND LOCAL CODES, OR INTHE ABSENCE OF

LOCAL CODES, WITH THE LATEST EDITION OF THE

NATIONAL ELECTRICAL CODE. THIS PUBLICATION IS AVAILABLE FROM

YOUR LOCAL GOVERNMENT, ELECTRIC CO., PUBLIC LIBRARY, OR BY

WRITING UNDERWRITERS LABORATORIES, 333 PFINGSTEN RD.,

NORTHBROOK, IL. 60062

TEL:1-800-543-6163, 203-267-7890, FAX: 203-267-7975, e-mail: eemaxinc@aol.com

IF YOU REQUIRE HELP OR HAVE ANY QUESTIONS RELATING TO THE

INSTALLATION OR PERFORMANCE OF THIS HEATER, PLEASE CALL

OUR TECHNICAL SERVICE DEPARTMENT TOLL FREE:1-800-543-6163.

HAVE THE INFORMATION LISTED BELOW BEFORE CALLING:

MODEL NO.___________SERIAL NO.___________INSTALLATION DATE_____

RELAY

PART # EX250-

255

ELEMENT CARTRIDGE

HEATER MODEL/ORDER REF. CARTRIDGE REF #

SP2412 (120V) EX610SP

SP3012 EX480SP

SP3512 EX410SP

SP3208 (208V) EX1440SP

SP4208 EX1050SP

SP8208 EX520SP

SP35 (240V) EX1650SP

SP55 EX1050SP

SP65 EX890SP

SP75 EX770SP

EX95 EX630SP

SP3277 (277V) EX260SP

SP4277 EX1870SP

SP60 EX1280SP

SP80 EX960SP

SP90 EX850SP

SP100 EX760SP

relay

Summary of content (4 pages)

PAGE 1
Replacement Parts for “Single Point” Units ½’’ PIPE (5/8’’OD)COMPRES SION NUT AND SLEEVE PART# EX16, EX17 ® 3/8’’ COMPRESSION ADAPTOR WITH NUT AND SLEEVE PART#EX68A,B,C UP INSTANT COMFORT…ENDLESS SAVINGS “Single Point” ELECTRIC INSTANTANEOUS WATER HEATER INSTALLATION GUIDE AND OWNERS MANUAL UP INSTALL THIS WAY UP CONTROL BOARD EX182DP SPECIFY VOLTAGE AND MODEL WARNING BEFORE ATTEMPTING INSTALLATION OF THIS UNIT OR MAKING ANY ADJUSTMENTS TO THE UNIT, ALWAYS BE SURE CIRCUIT BREAKER IS OFF TO PREVENT D
PAGE 2
GENERAL The Eemax “Single Point” heater is specifically designed to be installed “under sink” feeding a SINGLE faucet(5.5kW and lower) It is designed to take in cold water ONLY and heat it to temperatures suitable for hand washing. To obtain optimum performance and energy savings, the unit should be located as near as possible to the point of use. The heater incorporates a constant flow device and should only be used with the faucet aerator supplied with this heater by Eemax.
PAGE 3
2) PLUMBING HOOK-UP 4) COMMISSIONING YOUR HEATER IMPORTANT Before switching “on” the power at the breaker make sure that the hot water circuit is free of air pockets or premature failure of the heating element will occur. To do this open all hot water faucets one at a time for a minute or two until the water flow is continuous and free from “gulping” and from visible air pockets. 1) With inlet and outlet BALL VALVES fully open, turn on all hot water outlets.
PAGE 4
3) ELECTRICAL HOOK-UP FIGURE 2 WARNING BEFORE BEGINNING ANY WORK ON THE INSTALLATION BE SURE THAT THE BREAKER IS “OFF” TO AVOID ANY DANGER OF SHOCK. OUTLET VALVE (B) (ADJUST TO GIVE INLET VALVE(A) APPROXIMATE (FULLY OPEN) DESIRED TEMP.) Your Eemax heater must have its own independent circuit using insulated, UL listed, 3 wire cable of the appropriate size suitable for use up to 75 oC protected by the correctly rated circuit breaker. RATINGS OF “SP” UNITS MODEL VOLTS kW AMPS 0.