Use and Care Manual

PAGE SIX

The Indicator light comes “on” but there is no heat or the

water temperature is low:

STEP ONE:

The water flow is too high. Reduce the water flow using the faucet,

with experimentation you should notice an increase in temperature.

Make sure the aerator supplied with the heater is attached to the faucet,

these are integral to the proper performance of your heater. If you do not

have the special Eemax aerator call Eemax at 1-800-543-6163 and we

will send you one.

STEP TWO:

Make sure that the unit is connected to the voltage supply specified on the

U.L. rating label on the front cover of the heater and no other.

STEP THREE:

Take a resistance reading of the element. To do this follow instructions

on page five.