Use and Care Manual

PAGE SEVEN

Other possible solutions:

STEP ONE:

Make sure the printed circuit board is mounted in the correct position. This

is the top set of mounting holes. (see diagram below). Failure to mount the board in the

correct position will cause element burn out and may cause further damage to your

heater. (This board may have been incorrectly moved when serviced previously.)

The correct mounting holes

for the PCB on an “SP” model.

STEP TWO

Inspect the inlet filter (see diagram on page four for location). Make sure

it is free from debris, pipe dope or anything else which may hinder water flow.

IF HAVING CARRIED OUT ALL THE TESTS LISTED ABOVE YOUR HEATER

IS STILL NOT FUNCTIONING PLEASE CALL THE TECHNICAL SUPPORT LINE

AT EEMAX : 1-800-543-6163

PLEASE HAVE THE FOLLOWING INFORMATION AVAILABLE :

1) ORDER REF. NUMBER ( on U.L. rating label on the front cover of unit.)

2) SERIAL NUMBER (inside unit on backplate)

Board mounted in correct

position