Installation & User Manual

EX07200-121 Rev B
Manufacturer’s National Service Department | 400 Captain Neville Dr. Waterbury, CT 06705
Eemax® 800-543-6163 | EcoSmart® 877-474-6473 | Rheem® or Richmond® 800-374-8806
Information contained in this document is subject to change without notice.
7
4. ELECTRICAL HOOK-UP
BEFORE BEGINNING ANY WORK ON THIS INSTALLATION, CONFIRM THE ELECTRICAL BREAKER IS “OFF”
AND THAT ALL MOUNTING AND PLUMBING WORK HAS BEEN COMPLETED PER THE STATED
INSTRUCTIONS.
For use on an individual branch circuit only. The heater shall be installed using insulated, UL listed, 2 wire cable (2 wire plus ground)
of the appropriate size suitable for up to 75°C and protected by the correctly rated circuit breaker.
Open the hot water faucet and run water for a minimum of 60 seconds and until the flow is continuous and free of air pockets.
Close the faucet and install the aerator (if supplied).
Failure to install aerator will result in less-than-favorable heater performance.
MODEL
# OF
AERATORS
LAVADVANTAGE**
SPEX3512T ML
2
SPEX35T ML
2
SPEX48T ML
2
SPEX55T ML
2
SPEX65T ML
2
SPEX75T ML
2
SPEX95T ML
3
SPEX012240T ML
3
MODEL
# OF
AERATORS
LAVADVANTAGE**
SPEX3208T ML
2
SPEX4208T ML
2
SPEX3277T ML
2
SPEX4277T ML
2
SPEX8208T ML
3
SPEX60T ML
2
SPEX80T ML
2
SPEX90T ML
3
SPEX100T ML
3
MODEL
# OF
AERATORS
ACCUMIX II
AM004120T
1
AM005240T
1
AM007240T
2
AM010240T
3
AM012240T
4
AM004277T
1
AM008277T
2
AM010277T
3
**ML thermostatic models are designed to deliver a flow of 0.35 GPM to each
lavatory. Please install the supplied aerators to ensure maximum heating
performance.