Operation Manual

#
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
13
SC BSS 8000 ECO - 100818
Assembly page 13/28
Fax [phone]
OPERATIONS
• When your appliance is assembled, you just need to pull out
the power cord up to the desired length. A yellow mark on the
power cable shows the ideal cable length. Do not extend the
cable beyond the red mark, as this would damage the cord
rewind mechanism. Should you exceed the red mark, no
guarantee claims will be accepted. Put the plug in the power
socket and switch on the appliance by pressing the ON/OFF
switch with your foot.
• You can adjust the suction power with the electronic power
regulator or you can also adjust the suction power by using the
wind-force adjuster on the handle of the flexible hose. Use a
low suction power for furniture and other delicate surfaces and
use high suction power for fitted carpet and other floors.
AFTER USE
• Stop the vacuum cleaner by pressing the ON/OFF switch.
• Unplug the appliance from the power supply.
• Simply press the cord rewind button down to activate the cable rewind mechanism.
Guide the power cord in order to prevent it from becoming entangled.
REPLACING THE DUST BAG AND CLEANING THE FILTERS
The filter system consists of: motor filter
HEPA air filter, to vacuum the smallest particles
It is necessary to clean the filters regularly to avoid operating problems.
Paper dust bag
• The dust bag level indicator indicates when the dust bag should be replaced.
• The hose might get blocked by a larger object. In this case the dust bag level indicator will
be red. However this does not mean that you have to replace the dust bag. Just remove
the object which blocks your tube or flexible hose, and your appliance will function
properly again. Do not forget to unplug the appliance before removing the blocking
object.
• Replace the dust bag when the dust bag level indicator is completely red. First switch off
the appliance and unplug it.
• Open the cover by pressing the release button (8).
• Remove the dust bag and throw it in the dustbin.
• To put a new dust bag in the appliance, proceed the other way around, taking the
direction indicated on the dust bag into consideration.
• Make sure to put it correctly in the appliance, i.e. make sure that the hole in the dust bag
carton is right across the hose connection inlet.
• Close the cover by pressing it slightly.
Motor filter
To clean the motor filter, remove it and wash it in water (approximately every 3 months). Let it
dry completely before putting it back in the appliance.