Installation Instructions User guide
Table Of Contents
- Table Of Contents
- Section 1: General Notes And Guidelines
- Section 2 - Parts Identification
- Section 3 - Static Starter Sill Preparation and Installation
- Section 4 - Dynamic Starter Sill Preparation and Installation
- Section 5 - Dynamic Starter Sill Anchor Installation
- Section 6 - Intermediate Floor Slab Anchor Installation
- Section 7 - Unit Inspection and Preparation for Installation
- Section 8 - Setting Units at Static Starter Sills
- Section 9 - Setting Units at Dynamic Starter Sills
- Section 10 - Setting Typical Intermediate Units
- Section 11 - Setting Assembled (One Piece) Corner Units
- Section 12 - Applying Critical Seals
- Section 13 - Applying Typical Perimeter Seals
- Section 14 - Deglaze / Re-glaze Procedures - Captured System
- Section 15 - Deglaze / Re-glaze Procedures - SSG System
EFCO 2009 Page 7
Series 8700 / 8800 Unitized Curtain Wall Installation Instructions
Section 2 - Parts Identification
EXTRUSION
Profile Part #
Description
Tooling Drawing/Cut Formulas
17D6
FABRICATED #
FM03
7" STACK SILL MULLION
ANCHOR BAR
REFERENCE FM03 PART
DRAWING
17J3
FABRICATED #
FM04
8" STACK SILL MULLION
ANCHOR BAR
REFERENCE FM04 PART
DRAWING
17D1
FABRICATED #
FM11
MULLION ANCHOR
REFERENCE FM11 PART
DRAWING
17D2
FABRICATED #
FM05 & FM06
HOOK ANCHOR LEFT (FM05)
HOOK ANCHOR RIGHT (FM06)
REFERENCE FM05 AND FM06
PART DRAWINGS
17F3
FABRICATED
FM07
90° OUTSIDE CORNER
MULLION ANCHOR
REFERENCE FM07 PART
DRAWINGS
17F4
FABRICATED
FM08
90° INSIDE CORNER MULLION
ANCHOR
REFERENCE FM08 PART
DRAWINGS