Operation Manual

24
25 26 27 28
Italiano English Français
UTILIZZO - ARRESTO MOTORE USE - STOPPING ENGINE UTILISATION - ARRET MOTEUR
UTILIZZO
TRAZIONE (Mod. con riferimento T).
Per azionare l’avanzamento portare il comando frizione
(C) in contatto con il manubrio (B) (Fig. 25).
REGOLAZIONE ALTEZZA TAGLIO
SOLO CON MOTORE FERMO E PRESA DI CORRENTE
DISINSERITA.
Agire sulla leva (A) per variare l’altezza di taglio nella
posizione desiderata (Fig. 26).
Mod. con riferimento T
Fare ruotare la leva (D, Fig.27) a destra o a sinistra per
abbassare o alzare il rasaerba.
ARRESTO MOTORE
Rilasciare la leva (B) (Fig. 28).
ATTENZIONE: Dopo aver tolto la spina o aver
rilasciato la leva (B) il motore elettrico e la lama
continuano a girare per circa 3 secondi.
ATTENZIONE – Verificare, prima di ogni utilizzo,
che il rilascio della leva motore provochi
l’arresto del motore in pochi secondi. Fare
verificare il corretto tempo di arresto della lama
periodicamente da un Centro Assistenza
Autorizzato.
USE CUTTING
DRIVE (Models with reference T).
To activate the drive, pull slowly the clutch lever (C)
right back to handlebar (B) (Fig. 25).
ADJUSTING THE CUTTING HEIGHT
DO THIS ONLY WITH THE MOTOR OFF AND THE
MACHINE DISCONNECTED FROM THE ELECTRICAL
SUPPLY.
Use lever (A) to adjust the cutting height to the desired
position (Fig. 26).
Models with reference T
Turn the lever (D, Fig.27) to the right or to the left to
lower or raise the lawnmower.
ENGINE STOPPING
Release the lever (B) (Fig. 28).
WARNING: when the plug is removed or the
lever released (B), the electric motor and the
blade continue to turn for about 3 seconds.
WARNING – Before using the machine, always
make sure that the motor stops within a few
seconds of the motor lever being released. Have
the blade stoppage time periodically tested by
an Authorised Service Centre.
TONTE
TRACTION (Mod. réf. T).
Pour actionner la traction armenez la commande
d’embrayage (C) en contact avec le guidon (B) (Fig. 25).
RÉGLAGE DE LA HAUTEUR DE COUPE
UNIQUEMENT MOTEUR ARRETE ET PRISE DE
COURANT DEBRANCHEE.
Agissez sur le levier (A) pour varier la hauteur de coupe
et fixez la position souhaitée (Fig. 26).
Mod. Réf. T
Faire tourner le levier (D, Fig.27) à droite ou à gauche
pour abaisser ou soulever la tondeuse.
ARRET MOTEUR
Lâchez le levier (B) (Fig. 28).
ATTENTION: après avoir enlevé la prise ou lâche
le levier (B), le moteur électrique et la lame
continuent à tourner pendant environ 3
secondes.
ATTENTION – Avant d'utiliser la tondeuse,
s'assurer que le moteur s'arrête immédiatement
après avoir relâché le levier. Faire contrôler
régulièrement si la lame s'arrête en un temps
correct auprès d'un Centre d'Assistance Agréé.