Operation Manual

27
I
GB
F
D
E
SK
P
GR
TR
CZ
RUS
UK
PL
CAUTION:
- Match your fuel purchases to your
consumption; don’t buy more than you
will use in one or two months;
- Store gasoline in a tightly-closed
container in a cool, dry place.

CAUTION - For the mixture, never use a
fuel with an ethanol percentage higher
than 10%; gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10 fuel are
acceptable.
NOTE - Prepare only the quantity of mixture
required for immediate use; do not leave fuel in
the tank or a container for a long time. Were
commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be
stored for 30 days.
Alkylate gasoline

CAUTIONS – Alkylate fuels have different
density than normal fuel. Therefore
engines, set with normal fuel, need different H
jet regulation to avoid critical issues. For this
operation it’s necessary turned at a Licensed
Service Dealer.
FILLING THE TANK
Stir the mixture well before refuelling.

WARNING: Follow safety instruction for
fuel handling. Always shut off engine
before fuelling. Never add fuel to a machine
with a running or hot engine. Move at least 3
m from refuelling site before starting engine.
DO NOT SMOKE!
1. Clean surface around fuel cap to prevent
contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank.
Avoid spillage.
4. Prior to replacing the fuel cap, clean and
inspect the gasket.
5. Immediately replace fuel cap and hand
tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks, if any
are found, correct before use. Contact a
Servicing Dealer if necessary.
OIL FILLING AND CHAIN LUBRICATION
The saw chain is automatically lubricated during
use by a pump which normally requires no
maintenance. The oil flow is pre-regulated by the
manufacturer to ensure a sufficient oil delivery
even under heavy working conditions. During
cutting of thin timber a possible oil dripping is
normal.
- Always wipe off around the filler hole before
unscrewing the cap (13, Fig. 2) so that no dirt
enters the oil reservoir.
- During work watch the oil level.
- After the filling, operate the motor 2 or 3 times
to restore correct oil delivery.
- In case of faults do not try to repair the
machine yourself, but apply to your authorized
dealer.
Correct chain lubrication during the cutting
phase reduces wear to a minimum between the
chain and bar thus prolonging life. Always use a
good quality oil.

WARNING - Never use waste oil.
Always use biodegradable lubrificant
(eco-lube Oleo-Mac/Efco) which is specific
for bar and chain and also respectful towards
nature, operator health and chain saw’s parts.
Before starting make sure the chain is not
obstructed.

When the engine is idling the chain
must not turn. Otherwise contact an
Authorized Service Center to carry out a check
and fix the problem.

When the chainsaw is running, grip the
front handle firmly with your left hand
and the back handle with your right hand
(Fig. 11).
- Do not lean forward and do not cut above