CONTENTS INTRODUCTION Energy metering and monitoring are at the heart of energy management: you need the information to tell where and when you’re saving money. The elite wireless electricity monitor shows the amount of energy that a household is consuming at the time the display is read. The display can also give the user a reading showing usage in financial terms. You can walk around the home with your display device, switching appliances on and off, to see the diffrence that each one makes.
SAFETY IN THE BOX IT IS IMPORTANT THAT YOU OBSERVE SOME SIMPLE PRECAUTIONS BEFORE USING THIS PRODUCT. Your efergy elite Pack contains the following elements When installing the efergy monitor you should find that everything is relatively straight-forward. However, there are a number of important health and safety issues which you need to be aware of.
FIND THE FEED CABLE The efergy monitor is installed by clipping the sensor around the feed cable of your electricity meter. Locate Your Electricity Meter Diagram 1 Locate your electricity meter and determine its type. You can normally find this on an outside wall, in the garage, basement or utility room. If you live in a flat, it can often be found outside your front door, in the communal staircase, or in the basement.
INSTALLATION LINKING TRANSMITTER AND DISPLAY 1. Fit The Sensor The sensor needs to be fitted to the live feed cable. Sensors are suitable for cables up to 12mm in diameter. You should not force the cable to fit. The sensor should fit loosely around the cable and there should be no packing used. 1. Ensure three AA batteries are inserted in the transmitter and three AA batteries inserted in the display unit. If the LINK is COMPLETED you will see the transmission signal 2.
SETTING THE TIME & DATE SET-UP INSTRUCTIONS The efergy monitor needs to know the time and date in order to provide you with the correct information. Set the time and date as follows: Step 1 On the reverse of the display you will find the TIME button. Press and hold for two seconds. Date set up will flash in the display. 2 seconds Step 1. Voltage Press and hold Mode button for two seconds. Default voltage is set at 240V. Use BWD and FWD Buttons to change the voltage.
Step 3. Single Tariff Set Up On release you will see the symbol flash. If you are charged one single tariff push Mode button to confirm. If you have dual tariff rate, please see the following page. History BWD FWD Mode If you have a dual tariff rate meter you may want to set-up the dual tariff function. Throughout the set-up process, push Esc Button at any time, your settings will be saved & you will exit the function setting mode. History BWD FWD Mode Step 4.
INSTANT INFORMATION Example: If you are on an economy-7 tariff which starts at 1am and finishes at 8am, set start at 01:00 set at 08:00. Push the Mode Button to confirm. Select the currency and set the cost per kWh you pay for each tariff, approx 5p/kWh and 12p/kWh for night and day time rates respectively. Esc. BWD FWD Mode Push the Mode Button to change information being displayed from kW to costs per hour. Energy Now Instant power, in kW. Costs per hour: estimated costs in one hour (£ per hour) Step 3.
HISTORY MODE FAQS Days, weeks, months Push the History Button to access daily, weekly and monthly stored data Use the BWD and FWD buttons to scroll between dates and compare consumption data History Push the History Button to access daily, weekly and monthly stored data Push the Mode Button to change information display from kWh to costs and CO 2 emissions 14 If I remove the batteries will I lose the information on the display? If you need to change or remove the batteries, the display has an internal
SPECIFICATION Model Name/Number: efergy elite 2.0 Frequency: 433.52MHz Transmission Time: 6s. 12s. o 18s. Transmission Range: 40m-70m Voltage Range (in the sensor): 110V-400V Measuring Current: 50mA-95A Accuracy: >90% The LED backlight will be activated from 18:00Hrs to 6:00Hrs. Carbon ratio: 0.50 kg.
