User guide

SpeedStream Router User Guide
LED Power
(pwr, Power)
DSL
(dsl, T-DSL, Activity,
Sync)
USB
(usb)
Ethernet*
(enet, Ethernet, LAN)
Blinking
Red/Green
Flash Write in
progress
N/A N/A N/A
Red - POST tests in
progress (first
30 sec. after
powering on
or rebooting)
- POST error
occurred
N/A N/A N/A
*Note The 5100 and 5400 series SpeedStream routers have one Ethernet LED; the 5200 and 5500 series
have four Ethernet LEDs, one for each Ethernet port.
Resolving Specific Issues
LEDs Not Lit
• pwr
If the pwr (power) LED is not lit, it is not connecting to the power source. Verify that the power cord
is firmly plugged into the back panel of the router and that the other end is plugged into an active AC
wall or power-strip outlet.
• dsl
If the DSL LED is not lit, it is not detecting a valid signal from the Central Office (CO). Verify that
the DSL cable is plugged into the correct router port and the router power cord is plugged into the
electrical outlet. If the cables are secure, you should contact your Service Provider.
• enet LED Not Lit
This indicates that there is no Ethernet link detected. If you are using the Ethernet connection method,
check the Ethernet cable connection from the computer to the router. If you have used the wrong
cable, the LED on the Ethernet (NIC) card in your computer will not be lit either.
• USB LED Not Lit
This indicates that there is no USB link detected. If you are using the USB installation method, check
the USB cable connection from the computer to the router.
Login Password Error
If after being prompted for the login password, you receive the error message: Login Password is
invalid:
•
Retype the password, and then click Save Settings.
• If you forget your password, you must reset the router.
Note The password is case-sensitive. Be sure that you have not accidentally activated the Caps key.
91