Use and Care Manual

Assembly InstructionsAssembly Instructions
Parts List
Wire Shelf
No.
Name
Parts
Qty
A B C D E
Upper Pole Lower Pole Plastic Clip Leveling Foot
4PCS 4PCS 4PCS 40PCS 4PCS
Screw the Leveling Feet (E) into the bottom of Lower Pole. Snap the Plastic
Clips (D) into the pole grooves of lower poles(C) at the same position and
make sure that the arrow of plastic clips are pointing up.
Please make sure that you have the wire shelf (A) the correct way up. (The
gap in collar shall be faced down) Hold the shelf on its side and slide the top
of four lower poles through the bottom of each shelf at its corners until there
is a snug fit. After 4 poles have been
slid through the shelf collar holes,
set the shelf upright.
Keep the gap in collar face down
Raise Lower
Plastic Clips’ arrow
should point up
1
Refer to Step 1 to snap the plastic clips on the grooves of four pieces of
lower poles at your desired position and slide down the wire shelf from the
top of each lower pole down onto the plastic clips.
*To ensure the
stability of the
shelves, make
sure all 4 clips are
attached to the
same layer on
the pole.
*
3
Refer to the Step 3 to snap the plastic clips on the same grooves of each
pole on your next desired position to assemble the other 3 wire shelves.
5
Push firmly down on every wire shelf at its corners with a rubber mallet to
ensure all the shelves are properly in place over the plastic clips. To attain
proper leveling, screw the leveling feet inwards or outwards.
6
Screw upper poles(B) into lower poles using the connectors from both ends.
4
2
!
A
B
C
D
E